September 2026 - Jukebox-list - lists.netlojix.com

Selection not working after changing fluorescent tube.
by connie cleek 24 Oct '26

24 Oct '26

I have a Rockola 444. I changed a fluorescent tube and it it lit up for a second and burned out. I should have done it with the machine turned off, but I didn’t. Since then, when I push the selection buttons, they stay depressed and nothing happens. I’ve checked the fuses and replaced the 2 ballasts. What else should I do to get it working again? The record wheel turns fine when I use the manual scan. Sent from my iPhone

4 3

Wurlitzer 2410S remote cancel button?
by Steve Wahl 22 Sep '26

22 Sep '26

Hi, all, I have a Wurlitzer 2410S that has become slightly unreliable clamping the record. I made a small adjustment to the lift arm height that might have fixed it. But the machine is in a position where the cancel button is hard to reach, so in case it happens again, I was thinking a remote cancel button would be a good idea. I was assuming that it'd be possible to wire something like a doorbell button somewhere. I was surprised to see adding a remote cancel button wasn't covered in the manual I have, not even mention of an available remote to add to it. And from reading the schematics, it looks like it might take a 3-wire, SPDT switch, not just a normally open "doorbell" switch to make this happen. Is that right? Was there an offical remote switch that could be added? How did it connect? Thanks, --> Steve -- Steve Wahl steve(a)5wahls.com

6 8

Seeburg Blue Needles
by Jim McClave 20 Sep '26

20 Sep '26

Is there any suitable and affordable sets of Seeburg Blue needles for a mono redhead cartridge available?

6 6

Wurlitzer 2310S Amplifier
by Dean Carriveau 16 Sep '26

16 Sep '26

Hi all, I've been asked if I know of anyone who could rebuild or repair the amplifier in a Wurlitzer 2310S. He's located int the Tri-cities area (Richland, WA) on the Washington/Oregon border. I advised him to look for a shop that could rebuild it in his area and the nearest place he could find was in L.A. and Denver area. He indicates the sound quality is poor and that the caps and tubes are probably in need of replacement. I advised that the caps are 65-plus years old and could probably stand to be replaced. Any suggestions as to who might be a good contact for him? Thanks, Dean

4 4

Seeburg Low volume
by Jim McClave 10 Sep '26

10 Sep '26

Forgot to mention, the cartridge is removed when I am reading the high resistnce.

1 0

Seeburg C Low Volume
by Jim McClave 10 Sep '26

10 Sep '26

Amp rebuilt . good tubes, etc. Volume still too low. With ohmeter I am reading @ 3.5 Megohms between the center conductor and shield ground on the PU input cable that plugs into the amp. Is this normal? I would think It should read totally open. Could this resistance be bogging down my volume? Not sure of cartridge status. thanks for any help .

1 0

amp needed
by Jukebox Repairman 10 Sep '26

10 Sep '26

Customer bought a machine that's missing the amp. Need a HFMA2 Seeburg amp. Any list members have one ? Preferably a known good one no sizzling transformers. Thanks Rick

2 1

6P3S - 6L6GT, 6L6.
by Tony Miklos 08 Sep '26

08 Sep '26

Are the 6P3S's a good substitute for a 6L6**? I read that they are rated lower output than some 6L6's, but who plays their JB at full volume anyway? Or would the plate voltage have to be lower? Tony

1 0

Test posting
by Jay Hennigan 01 Sep '26

01 Sep '26

We had a power outage and generator failure at the datacenter hosting the list. Making sure all is good. Please ignore. -- Jay Hennigan - jay(a)west.net Network Engineering - CCIE #7880 503 897-8550 - WB6RDV

1 0