[Jukebox-list] Re: Wurlitzer NyNy

On 2024/04/11 12:17 p.m., Jukebox Repairman wrote:

Well with the aid of the schematic I discovered why the tube heaters and the animation were not working.  The connector was dangling in the air.  Plugged it in and all works now.

Only downside is now the clamp arm is back to sticking upright after disc loading. When it unloads from the player it goes up high enough to clear the gripper. Nice and smooth motion.   I guess I have to remove the mech and get a look underneath

Regards Rick

Does the lift plunger move freely? Could be gummed up lube...

John :-#)#

On Wed, Apr 10, 2024 at 8:49 PM Jukebox Repairman jukin510@gmail.com wrote:

I’m on it.
Thanks again

On Wed, Apr 10, 2024 at 8:48 PM John Robertson via Jukebox-list
<jukebox-list@lists.netlojix.com> wrote:

    Hi Rick,

    I was just checking the schematics (#4 OMT & NYNY CD manual -
    I sell
    copies) and the NY New York has a small distribution PCB for
    the bubble
    tubes and motor. Remove the board and check the backside for
    burnt or
    cracked trace(s) - I've seen more than a few fail this way!

    John :-#)#

    On 2024/04/10 5:18 p.m., John Robertson via Jukebox-list wrote:
    > Hi Rick,
    >
    > No, if the animation and none of the bubble tubes are
    running then you
    > have a power failure. Blown fuse or failure in wiring or
    connections.
    >
    > Check at the motor for the 24VAC needed. You have the
    schematics I
    > assume?
    >
    > John :-#)#
    >
    > On 2024/04/10 5:02 p.m., Jukebox Repairman wrote:
    >> John am I still looking at defective resistors if all four
    tubes
    >> stopped at once? Oddly the animation motor as well
    >>
    >> Regards
    >> Rick
    >>
    >> On Wed, Apr 10, 2024 at 6:52 PM John Robertson via
    Jukebox-list
    >> <jukebox-list@lists.netlojix.com> wrote:
    >>
    >>     On 2024/04/09 12:39 p.m., Jukebox Repairman via
    Jukebox-list wrote:
    >>     > John, thanks.
    >>     >
    >>     > I made the adjustment where the plunger meets the
    arm. It’s not
    >>     pushing it
    >>     > fully vertical now. It drops back down after disc
    meets the
    >> player.
    >>     > As always I appreciate your expertise and help.
    >>     >
    >>     > Now if I can get upper arch bubble tubes to go.
    >>     > I checked fuses all good
    >>     >
    >>     > Regards
    >>     > Rick
    >>...