Still working on the model 61. With the help of Hans I was able to replace the fibre gear, it went together well and works fine. (Thank you Hans) The problem now is that it keeps picking up the same record and the selector never searches. The problem is that at the end of the cycle the clutch does not reset forward and engage the selector gear. However if I advance the mech a bit it will do what it’s supposed to do. I’ve done the timing at least 5 times but it hasn’t corrected the problem, I’ve even tried advancing the timing a bit and retarding it a bit and still no luck so I just set the gear back to where it’s supposed to be. Is there an adjustment to make the motor run a bit longer? I’ve read the manual cover to cover but no mention of this. In the troubleshooting section it says to do the timing, but as I stated, this did not solve the issue. Any ideas much appreciated. Mauro
Sent from my iPhone