I don't know if it's tied to the CCC or just the amp, but try disconnecting the music decibel light display board. I'm assuming the voltages are good, but don't just go by the LED's. The CCC can have a lot less than 8vdc yet still light the led. Either way, try swapping power supplies.
Tony
On 9/11/2024 10:35 AM, Jukebox Repairman via Jukebox-list wrote:
This is going to be a bit lengthy so bear with me.
I was called to a customer home for his juke not working after his home sustained a lightning hit. I was told that a TV, Pool pump, Dishwasher all damaged. His juke was not powered on during the strike but shortly after he noticed it would not accept a selection.
In the display it would show first digit then when pushing 2nd digit button the display would go blank.
In service mode mech magazine would not rotate but you could hear a click from the sprag solenoid.
I replaced the mech controller board and no change. Next the Central computer still no change. I pulled his mech, Central computer, and power supply brought them back to my shop and tested each component one at a time in my shop machine and ALL his components work fine.
He brought the complete machine to my shop for further troubleshooting. I reinstalled all his original components and now in idle state the magazine motor is constantly receiving power pulses. If I manually operate the sprag assembly the magazine starts to rotate in a slow jerky motion. I even replaced the service switch but I am now at a loss what is causing this issue. Again all his original components operate properly in my shop machine.
I would welcome any input on what could be causing this.
Regards,
Rick _______________________________________________ Jukebox-list mailing list -- jukebox-list@lists.netlojix.com To unsubscribe send an email to jukebox-list-leave@lists.netlojix.com %(web_page_url)slistinfo%(cgiext)s/%(_internal_name)s Searchable Archives: http://jukebox.markmail.org/