Seeburg KD has been gone thru, boards rebuilt, mech removed, cleaned, lubed, all switches cleaned and checked with meter. When I make a selection, the motor will not start until I manually turn the coupling a few revolutions. Then it selects and plays just fine. "O" contacts are good and I installed a new motor cap with the same results. But here's the kicker - if I turn the motor in the "wrong" direction, it will start rotating that direction and play normally, even with the reversing switch flipped the other direction. While scanning, I can flip the reversing switch but it will not change direction. It will do this in either direction. Bizarre... The only way it changes direction is when it bangs into the hard stop and the motor temporarily stalls. I will try another motor tonight, just wondering if anyone has seen this before.