25 Aug
2018
25 Aug
'18
4:43 a.m.
On 8/24/18 8:55 PM, Ken Alker - KA6KEN via SBARC-list wrote:
Thanks, Al! All good suggestions and I'm going to note them for the future. I ended up temporarily just putting the mast INSIDE the 3.5" OD pipe (it is 3" ID and the OD of my mast is 2.25") and it is working fine for now, but it spins in the wind (not good :-), and is a little crooked.
How about pulling it out, then drill and tap the 3.5 pipe and put in some setscrews? You could go big with 1/4-20. Two sets of three setscrews a few inches apart would give some pretty fine control of centering and straightness.
--
Jay Hennigan - CCIE #7880 - Network Engineering - jay@impulse.net
Impulse Advanced Communications - http://www.impulse.net/
Your local telephone and internet company - 805 884-6323 - WB6RDV