I found a broken leg on one of the silicon rectifiers. I replaced it but haven’t tried installing it yet.
To answer your question… yes it scans to right and tries to keep going. It just bumps against the stop.
Rick
On Tue, May 12, 2026 at 3:12 PM Tony Miklos via Jukebox-list < jukebox-list@lists.netlojix.com> wrote:
On 5/10/2026 1:01 PM, Jukebox Repairman via Jukebox-list wrote:
Still looking for help with this control center. The mech will scan completely to the right but will not engage the reversing relay. As
stated
previously normally I would suspect the reversing switch, but when my TCC is installed everything works fine.
I am unable to determine where the problem lies and there is no
description
relevant to the problem in the manual.
I am testing it in my hideaway unit.
Hoping someone can point me in the right direction.
Thanks Rick
If the mech is manually moved to the left, and the tormat is "loaded" with a battery for both sides, does it select and play both sides properly?
When the mech gets to the right, does the motor keep trying to run the same direction, or does it just stop?
Is the #2 test plug installed? (IDK what that would do?) Or is a jumper wire in the plug broken?
Have you tested the RR coil itself?
Make sure none of the jack or plug terminals are getting pushed out when inserted.
I don't have the answers, just some things that came to me.
If I have a problem like that I often will take a jumper wire clipped onto the one relay coil terminal, bypass everything and test it direct to its power source testing the relay. If that works, keep following the schematic to the next point, which depending on the schematics quality, can be difficult.
-- Tony Miklos Tony's Jukebox Repair
Jukebox-list mailing list -- jukebox-list@lists.netlojix.com To unsubscribe send an email to jukebox-list-leave@lists.netlojix.com %(web_page_url)slistinfo%(cgiext)s/%(_internal_name)s Searchable Archives: http://jukebox.markmail.org/