Hello again! The reset solenoid 1 (or solenoid 2, must check which one, it's the one about even numbered records) in my Microtecnica Conti2, just stopped working, it doesn't matter which odd numbered selection I do. Everything else it's working fine, and if I reset the pin by hand for that selection, it's all ok. I don't see the reset coil even trying to reset the pins, but the plunger moves freely, if I push it by hand. So, I'd like to find a way to check it without dismounting everything, just to be sure it's a coil fault and not something else. First of all, at which voltage it's that coil operated? I suppose 110v ? Where does the impulse for the coil starts from? There's a place where I could check with a tester if everything else it's ok, just to be sure it's not a problem with some old cable, or a microswitch? Also, as far as you may know, there's any video around about how to access that solenoid...? Thanks! -- Federico Croci wiz@tilt.it www.tilt.it