First off I always appreciate the expertise and input from this group. So I cycled the mech a few times and realized that the "forked" side of the gripper was sitting a lot higher than it should have been. it wasn't lining up with the record edge so when it lifted off the turntable the record was angled. What I discovered was the back end of the turntable deck was pitched downwards towards the magazine. making the forked side sit above the record edge. I made an adjustment and after a couple of trial runs I was able to set it correctly and it now returns the record to its respective slot every time. I would have achieved full closure but the customer had somehow damaged the needle since I was there previously. At least replacing that is a simple fix. Thanks Again for everyone's suggestions. Hopefully I'll sleep better tonight. Regards, Rick