Happy New Year!

For my December birthday this year, I received a cool LED “neon” light. It is quite large so I have it hanging above my sofa in my shack. The attached photo of it is a little weird looking. The blue doesn’t look like that in real life. I’ll have to get another photo at night.

Anyway, I know that LED drivers can be a source of RF noise, especially cheap ones that use PWM to dim the light from LEDs. The one that came with this piece was visibly “dirty” to the point that I swear that I could see the flicker at certain brightness settings. I put my portable scope on the DC LED dimmer/driver output and it was very ugly. 

I decided to do some research and see what I could learn about PWM and LEDs. Turns out that the frequency at which these drivers pulse the light varies from model to model with some pulsing the light on and off at as slow a frequency as ~200 Hz. Apparently that was enough for be to perceive flicker.  I found another unit that was more that three times faster (~600Hz) and swapped it in. The flicker went away and the picture on the scope looks a lot cleaner now.

In the attached video I show the “clean" output, then the “dirty" output. I can’t figure out how the dirty output  manages to even dim the light. It barely budges off of 12 volts while the clean driver has nice, neat square pulses.

I didn’t notice any noise on the ham bands with either, which is good. I have other LED drivers around the house that are noisier on the RF side. Maybe I’ll try swapping those out.

Here is another more detailed video I did a while back about tracking down RF noise around the house. My kitchen LED uplighting is a continual source of RF noise.
https://www.youtube.com/watch?v=keQmb2Maqes

LCM

Levi C. Maaia, K6LCM

www.levimaaia.com